Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• When work is completed – Remove the battery pack
from the snow blower when not in use, when changing
accessories, and before performing any maintenance task.
• Store safely – Store the snow blower indoors in a dry area
between uses. Keep in a locked area, where children and
unauthorized users cannot gain access. Never store the
snow blower with the battery pack installed. It may cause
damage and injury.
• Maintain for safety and longevity – Check for
misalignment or binding of moving parts, breakage of
parts, and any other conditions that may affect the unit's
operation. If damaged, repair or replace the damaged part
before use. Use only those replacement parts made for your
model. When replacing any parts, you must strictly observe
the instructions and procedures described in this manual.
Special care should be paid to any rubber parts, since
these parts may increase the motor load and decrease its
mechanical power if damaged.
• Rotating parts – Do not put hands or feet near or under
rotating parts.
Keep clear of the discharge opening at all times.
• Hidden hazards – Exercise extreme caution when
operating on or crossing gravel drives, walks, or roads.
Stay alert for hidden hazards or traffic.
• Exercise extreme caution when operating on slopes.
Never operate the machine at high transport speeds
on slippery surfaces. Look behind and use care when
operating in reverse.
• Never operate the snow thrower without good visibility or
light. Always be sure of your footing, and keep a firm hold
on the handles. Walk; never run.
• Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
• Never allow children to operate the equipment. Never allow
adults to operate the equipment without proper instruction.
• Adjust the collector housing height to clear gravel or
crushed rock surface.
• Always wear safety glasses or eye shields during operation
or while performing an adjustment or repair to protect eyes
from foreign objects that may be thrown from the machine.
Clearing a Clogged Discharge Chute
Hand contact with the rotating impeller inside the discharge
chute is the most common cause of injury associated with
snow throwers. Never use your hand to clean out the discharge
chute.
To clear the chute:
i) SHUT THE MOTOR OFF!
ii) Wait 10 seconds to be sure the impeller blades have
stopped rotating.
iii) Always use a clean-out tool, not your hands.
Electrical Safety
• Avoid accidental starting – Make sure the safety switch
and the ON/OFF trigger is in the OFF position before
inserting the battery pack into the unit. Do not carry the
snow blower with the safety switch and ON/OFF trigger
engaged.
5
Tabla de contenido
