Storage And Cleaning - Braun PrecisionSensor BP 2550 Manual Del Usuario

Activating/de-activating the active positioning
system
Repeatedly press the select button briefly until the
«OK» next to symbol of the position sensor « » is
flashing. With the I/0 button you can now switch
from «OK» (activated) to «–» (de-activated).
Activating/de-activating the statistics mode
Repeatedly press the select button briefly until the
present status of the statistics mode is flashing. With
the I/0 button you can now switch from «OK»
(activated) to «–» (de-activated).
If the statistics mode is activated («Ø»), it can be
called up with the memory button (monitor must
be turned off before). It will display a graphic
comparison of the most recent reading versus the
average value of all saved readings. Pressing the
memory button again will call up the individual stored
readings. Prolonged pressing of the memory button
will switch from memory «a» to «b» or vice versa.

Storage and cleaning

Clean the housing of the product with a damp, soft
cloth. Stains on the cuff (G) can be carefully removed
with a damp cloth. Do not wash or dry clean the cuff.
Do not store the product in a place exposed to direct
sunlight or high humidity. Do not submerge in water
and do not spill liquids on the device.
Calibration
This product has been calibrated at the time of
manufacture. If used according to the use
instructions, periodic re-calibration is not required.
If at any time you question the measuring accuracy,
please call at 1-888-848-2572.
10