Operation; Maintenance And Storage - BGS technic 9260 Manual De Instrucciones

V.

OPERATION

5.1- Intended use
•
The product is intended for indoor domestic use.
•
The product is intended for forward/reverse screwing.
•
Do not use the product for applications for which it is not intended and for uses not described in the
manual.
•
Any other use, other than that described in the instructions, is likely to damage the tool and to put
the user in serious danger
•
Do not apply tools or accessories on the product that are not recommended by the manufacturer.
•
The product is not intended for artisanal, commercial, professional and/or industrial use
5.2- Operation
WARNING: Recommendation for the use of a residual current device with a rated residual
current of 30 mA or less.
•
Ensure that battery is fully charged. Before initial use, ensure to charge battery pack fully.
•
Wear appropriate protective equipment.
•
Insert socket or accessory in the chuck. Only use accessories whose rated speed is at least equal to
the normal operation speed of the tool.
•
Prepare material for work
•
Secure material if necessary. Do not use your own weight or body to hold material.
•
Firmly hold tool to avoid kickbacks. Always maintain a balanced and secure position.
•
Place bit on material. Do not make sudden movements.
•
Press on switch (3) to start operation.
•
Once work is finished, stop product by releasing the switch (3). Note: do not put down product until
chuck has completely stopped rotating.
VI.

MAINTENANCE AND STORAGE

Before any intervention on product, ensure that switch is off and battery charger is
disconnected from its power source.
Reminder: Make sure to maintain the machine in good working condition, carry out regular maintenance
of the machine after each use and before storage .Any breach or default of adequate maintenance
reduces the life of the machine and increases the risk of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform maintenance
and proper cleaning, DO NOT use non-compliant replacement parts and do NOT dismantle yourself the
machine or change the security features.
6.1- Cleaning
a) Clean the plastic parts with a soft and clean cloth. Do not use aggressive cleansing agents (solvents,
abrasive cleansers) or an abrasive sponge or any sharp objects.
Do not use any caustic chemicals to clean the plastics parts.
Never put or immerse the product in water or any liquid, and ensure that water does not penetrate
the tool or the charger.
Never splash with water or clean with high pressure hose!
b) Clean chuck with a soft brush.
c) Clean ventilation holes with soft brush or spray air.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6 e s s a r t S
h c s m e R
Tel. +49 (0) 2191 / 46438-0
r e F ax +49 (0) 2191 / 46438-40 s u k r e v e
7 9 8 2 4 - D e
L
d . l h a t s w s @ o f n i : l i