IV.
GETTING STARTED
Before any intervention on product, ensure that switch is off and battery charger is
disconnected from its power source.
4.1- Unpacking
Remove product from its packaging. Check that tool and accessories are not damage.
4.2- Inserting and removing a socket
•
To install a socket on the anvil: Align the hole of the socket with the anvil and push down firmly.
Ensure it is centered and properly fixed.
•
To remove a socket from the anvil: Pull socket out firmly
.
4.3- Inserting and removing the battery
a) to insert the battery: slide the battery into the handle's base. Make
sure that the battery is securely locked.
b) to remove the battery: press the release tabs (7) and slide the
battery out of the handle's base
4.4- Charging the battery
1- Place battery charger on a flat and dry surface within 1m of a wall
socket
2- Insert battery into charger
3- Plug in battery charger to wall socket (power source) (Only use
with provided charger PRI 100-240V~50Hz 75W, SEC 18V
2500mA)
4- Charge during 1 hour.
5- After charging, disconnect battery charger from mains.
Note: Maintain the charger and the battery at a temperature
between +10°C et +40`°C
4.5- Battery charger LED indicator
The battery charger LED indicator (9) allows you to know the charging
status of your battery
Green LED illuminated means the charger is plugged and powered ON.
When red LED is on:
(*) Stop using the battery pack and acquire a new one at your local dealer.
4.6- Switch On/Off
To operate product, press on switch (3). To stop product, release the
switch.
4.7- Changing to Forward or Reverse mode
To change the rotation, press on the Forward/Reverse selector (2).
Note: do not abruptly change rotating direction when machine is operating
.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
Slow blinking: battery pack is charging.
Fast blinking: battery pack may be defective (*)
LED steady on: battery pack is fully charged
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
7
a)
Fig. 2
b)
Fig. 3
Fig. 4
9
Fig. 5
2
3
L
d . l h
a t s
w
s
@
o f n i
: l i