Kokido EV80 Manual De Usuario página 18

In order to maximize the cleaning efficiency, be sure to clean the filter screen before and
after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging base. Make sure the pool
vacuum is OFF
 Emptying filter base
1. Place the pool vacuum on a stable surface.
2. Release the rear body from the transparent lid.
3. Push on and rotate the tabs on the transparent round cover clockwise until the
orange bar on the transparent cover and the base are aligned. Lift the transparent
cover off the base. Hold the small grips on the top of the filter screen to lift it off the
base and gain access to the debris.
4. Clean out all debris from the base, suction nozzle flap, and draining filter plate. Use
clean water to rinse the entire base. To detach the filter plate, pry the rib of the plate.
If the draining filter plate is damaged, replace it with a new one before the next
operation.
Note: Do not remove the draining filter plate. Without it, debris will escape from the
base's debris compartment during operation.
5. Reverse the steps to install the filter screen and cover onto the base. Make sure the
flange of the transparent cover is under the arch.
17