Pro-Logix 1002 Manual Del Operador página 2

Figure 1. Charger Mounting
3. Check polarity of battery posts. Positive (POS, P, +) battery
post usually has larger diameter than Negative (NEG, N, –)
post. Determine which battery post is grounded (connected) to
the chassis. If Negative post is grounded to chassis (as in most
vehicles), see step a. If Positive post is grounded to the chassis,
see step b.
a) For negative-grounded vehicle, connect Positive (RED) lug
from charger to Positive (POS, P, +) ungrounded battery post.
Connect Negative (BLACK) lug to vehicle chassis or engine
block, away from battery. Do not connect lug to carburetor,
fuel lines, or sheet metal body parts. Make the connection to a
heavy gauge metal part of the frame or engine block.
Figure 2. Terminal Connections
b) If you have a positive ground system in your vehicle, you must
mark the two dc output cable conductors with the color currently
on each lug and remove the attached battery lugs. Switch the
lugs with new lugs of the same size but on opposite conductors.
Put the new, larger lug on the conductor that is black (must
remain identified as black or negative) and the new smaller lug
on the conductor that is red (must remain identified as red or
positive). The larger lug always connects to the battery and the
smaller lug connects to the engine block or chassis, away from
the battery.
For positive-grounded vehicle, connect Negative (BLACK)
clip from charger to Negative (NEG, N, –) ungrounded post
of battery (see MOUNTING CHARGER FOR CONTINUOUS
USE). Connect Positive (RED) clip to vehicle chassis or engine
block away from battery. Do not connect lug to carburetor, fuel
lines or sheet metal body parts. Make the connection to a heavy
gauge metal part of the frame or engine block.
If problems arise while trying to connect the output leads, solicit the aid of
your local auto supply store to find a suitable connection device for your
application.
OPERATING INSTRUCTIONS
This charger uses a voltage regulating control circuit that continually
monitors the battery voltage and automatically turns the output on and
off, safeguarding against overcharge. This battery charger is designed
to remain connected to the battery. However, if it becomes necessary
to disconnect the charger, disconnect ac line cord first, remove lug from
vehicle chassis (ground) and then remove the lug from battery terminal.
• To reduce risk of a spark near battery, position ac and dc line cords
to reduce the risk of damage by hood, door or moving engine part.
• Stay clear of fan blades, belts, pulleys and other parts that can cause
personal injury.
1. Connect the battery charger ac line cord (through a UL approved
842-257-501 B
extension cord) to a 120 Volt ac power outlet. Make sure the
extension cord is in good condition and the wire size is large
enough for the for the ac ampere rating of the charger (see
RECOMMENDED MINIMUM AWG WIRE SIZE FOR EXTENSION
CORDS FOR THIS BATTERY CHARGER).
2. Once the battery charger has been properly connected to the
battery and the ac outlet, the amber CHARGING LED will
light solid, indicating the battery is being charged. Once the
battery approaches full charge, the green LED will light solid.
Subsequently, the charger will perform a timed float charge for
approximately 5 hours and then enter maintenance mode. The
charger will resume charging if the battery's state of charge
declines.
3. The charger has reverse polarity and output short circuit protection.
If a reverse polarity condition exists, the Red LED will light solid.
If you encountered this situation, disconnect from AC power and
make a proper battery connection. If the charger identifies a
short condition in the battery, the Red LED will flash. Disconnect
the charger from AC power and then disconnect the battery
connections, disconnecting the negative lead first.
CHARGER MAINTENANCE AND CARE
A minimum amount of care can keep your battery charger working
properly for years. Just as with any appliance or tool, keep your battery
charger clean and dry. Occasionally cleaning the case and cables with a
dry or slightly damp cloth will prolong the life of your charger.
LIMITED WARRANTY
Manufacturer warrants that for 1 year from the date of original retail
purchase, it will repair at no charge for parts and labor, this product,
proven defective in material or workmanship. If, after reasonable efforts
by Manufacturer, the product is deemed not repairable, Manufacturer will,
at its option, refund the original purchase price or supply a replacement
unit.
THE TERMS OF THIS LIMITED WARRANTY CONSTITUTE THE
BUYER'S SOLE AND EXCLUSIVE REMEDY. IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE ARE LIMITED IN DURATION TO THIS EXPRESS
WARRANTY. AFTER 1 YEAR FROM DATE OF PURCHASE, ALL RISK
OF LOSS FROM WHATEVER REASON SHALL BE PUT UPON THE
PURCHASER.
MANUFACTURER SHALL NOT BE LIABLE FOR INCIDENTAL AND
CONSEQUENTIAL DAMAGES UNDER ANY CIRCUMSTANCES:
MANUFACTURER'S LIABILITY, IF ANY, SHALL NEVER EXCEED THE
PURCHASE PRICE OF THIS MACHINE, REGARDLESS OF WHETHER
LIABILITY IS PREDICATED UPON BREACH OF WARRANTY
(EXPRESS OR IMPLIED), NEGLIGENCE, STRICT TORT OR ANY
OTHER THEORY.
This warranty extends to each person who acquires lawful ownership
within one year of the original retail purchase, but is void if the product
has been abused, altered, misused or improperly packaged and damaged
when returned for repair. This warranty applies to the product only and
does not apply to any accessory items included with the product which
are subject to wear from usage; the replacement or repair of these items
shall be at the expense of the owner.
Some states do not permit the limitation of warranties or limitation of
consequential or incidental damages, so the above disclaimer and
limitation may not apply to you. This warranty gives you specific legal
rights, and you may also have other rights, which vary from state to state.
To obtain services under this warranty. Return if to your place of
purchase or send it ti the address below for repair/replacement:
Battery Charger Service
Kansas City, MO 64161
(913) 310-1050
www.solaronline.com
WARNING: This product can expose you to chemicals,
including Vinyl-Chloride, Styrene and Acrylonitrile, which are
known to the State of California to cause cancer. For more
information go to www.P65Warnings.ca.gov.
© 2018 Clore Automotive