Connecting The Camera - flir Lorex LZV2722 Manual De Instrucciones

4

Connecting the Camera

• It is recommended to connect the camera to your DVR and test the PTZ controls before
permanent installation. For instructions on how to setup PTZ controls, see 6 Controlling
the PTZ Camera with your DVR, page 16.
• When you first power up the camera and connect it to the DVR, it may take up to 2 mi-
nutes for the camera image to appear.
• The video signal can be extended up to 800ft (244m) with a single cable run. See 5.2
Extension Cables, page 6 for details.
1. Connect the BNC video connector on the camera cable to the included ex-
tension cable.
2. Connect the female AC 24V power connector on the camera cable to the
male power connector on the included extension cable.
3. Connect the BNC cable on the extension cable to one of the Video Input
ports on the DVR. Make note of the port number where you connect the
camera, as it will be used when configuring the DVR to communicate with
the camera.
4. Connect the power connector on the extension cable to the included
power adapter. Plug the power adapter into a power outlet.
•
•
#LX400025; r.32017/32017; en-US
NOTE
CAUTION
Make sure to disconnect the power adapter before installing the camera. The cam-
era will begin moving immediately when the power adapter is connected.
Make sure to remove the foam ring inside the camera housing before powering the
camera on for the first time. See 5.3 Installation (Indoor/Outdoor), page 8 for
details.
5