flir Lorex LZV2722 Manual De Instrucciones página 13

5 Installation
this setup, you must purchase a single run of RG59 coaxial extension ca-
ble. It is recommended to use a video cable with the following specification:
RG59U 95% Braid 20AWG or better.
RG59 coaxial cable should be available from your local building supply store.
5.2.1 Connection Diagram for Extending the Cables Beyond 100ft
(30m)
1. Connect the BNC video connector on the camera cable to a BNC exten-
sion cable up to 800ft (244m) long (not included).
2. Connect the female AC 24V power connector on the camera cable to the
included power adapter. Connect the power adapter to a power outlet.
•
•
3. Connect the BNC extension cable to one of the Video Input ports on the
DVR. Make note of the port number where you connect the camera, as it
will be used when configuring the DVR to communicate with the camera.
#LX400025; r.32017/32017; en-US
NOTE
CAUTION
Make sure to disconnect the power adapter before installing the camera. The cam-
era will begin moving immediately when the power adapter is connected.
Make sure to remove the foam ring inside the camera housing before powering the
camera on for the first time. See 5.3 Installation (Indoor/Outdoor), page 8 for
details.
7