Hoonved HC 3 Serie Instrucciones Para El Uso Y El Mantenimiento página 26

ENGLISH
SUMMARY TABLE of CYCLE LAMP (H3)SIGNALS
STATO DELLA MACCHINA
Machine on line but STAND/BY
CYCLE: washing, pause, rinsing
PROBLEMS CAUSES
The machine fails to
Main switch disconnected.
come on.
The machine does not fill
Water cock shut.
with water
Fill pipe filter dirty.
Rinsing nozzles clogged.
Overflow pipe incorrectly inserted.
Washing filter dirty.
Insufficient washing
Washing nozzles clogged.
Washing rod clogged.
Insufficient or no detergent.
Machine temperature not reached.
Washing conditions insufficient.
Insufficient rinsing.
Rinsing nozzles clogged.
Boiler clogged with scaling.
Low mains pressure (less than 200 kPa).
Temperature insufficient.
Incorrectly positioned nozzles or
nozzles deformed.
26
Machine OFF
ALARM: lack of heating
TROUBLESHOOTING
Part 2: For the operator
CONDIZIONE H3
OFF
ON CONSTANT
SLOW flashing
RAPID flashing
SOLUTIONS
Turn on the switch.
Turn on the cock.
Detach the fill pipe (12 Fig. 6) and clean the filter (13).
Unscrew and clean the nozzles (26 Fig. 10) under running
water.
Make sure that the overflow pipe (21 Fig. 10) has been
correctly inserted.
Clean the filter (22 Fig. 10).
Demount and clean the washing nozzles under running
water (27).
Demount and clean the rod (25 Fig. 10).
Top up the detergent in the canister and check its concen-
tration.
Wait until the tank water has reached the right temperature
(50°C).
Make sure that the washing phase takes place correctly.
Unscrew the nozzles (26 Fig. 10) and clean them under
running water.
Contact the after-sales service.
Wait until the pressure returns or purchase a pressure pump.
Contact the after-sales service.
Make sure that the nozzles are in their correct positions.
Replace any damaged ones.