Hoonved HC 3 Serie Instrucciones Para El Uso Y El Mantenimiento página 23

Part 2: For the operator
2.1 WASHING PHASES HC/HSP/HCR
2.1.a Switching on and Preparing the machine
To switch on the machine, press the power switch (Q1)
into the ON position.
In mean time, the line lamp (H1) will be lit and this litled
will indicate that machine is switched on.
The boiler, and then the tank, will start to fill automatically.
When the right level of water in tank is reached, the cycle
lamp (H3) will be FIXED lit.
Once the water level has been reached, the heating
elements will switch in, first in the boiler, then in the tank.
Once the water in the tank reaches the correct tempera-
ture, the tank temperature lamp (H2) will be FIXED lit.
WASHING OPERATION
If not using the equipped automatic dosing system, pour
into the tank a quantity of detergent suitable for the volu
me and hardness of the water.
For quantities, refer to the specific instructions for the
detergent in use.
ATTENTION
When items to be washed are encrusted with burnt
on matter, or a long time has passed between use
and washing, it is essential to carry out a pre-was
soak using a suitable softening agent.
The use of hand-washing products is to be avoided
as they could produce foam inside the machine.
IMPORTANT
It is advised to install a detergent pump automatic
rifle (to see paragraph 3,2).
Place the basket of items to be washed inside the machine,
having first removed any solid waste.
2.1.b During of Cycle
The duration of the washing cycle is FIXED.
2.1.c STARTING THE WASHING CYCLE
To start the washing cycle, press and hold the (S3)
button for a few seconds, then release.
Throughout the washing cycle the lamp
ATTENTION
The use of the machine ensures rinsing at the ideal
temperature for hygienic purposes every time;
Indeed, if the temperature is not sufficient the wash will
be automatically prolonged so as to ensure the neces-
sary conditions of optimum rinsing at
The waiting time required to attain optimum temperature
can extend to a maximum of 8 minutes.
While this is taking place, the (H3) lamp will FLASH RA-
PIDLY until the end of the cycle. To reset the flashing,
switch the machine off and back on using the power
switch (Q1) .
2.1.d Interrupting the cycle
1) It is possible to interrupt the washing cycle momen-
tarily by opening the door, this is an EMERGENCY
measure:
On closing the door, operations will resume from the
point in which they stopped.
2) The cycle can also be interrupted by SWITCHING
the machine's power switch (Q1) to the OFF position.
Allow items to dry and remove them from the basket
with clean hands.
Store all items on hygienic and completely stable sur-
faces.
2.1.e Manual Draining
It is possible to drain the water from the tank at any time
during the day, according to the waste accumulated.
To carry out this operation, proceed as follows:
- SWITCH the machine's power switch (Q1) to the OFF
position and release the overflow, allowing all the water
to drain from the tank;
- Remove the tank filter (22) and clean;
ENGLISH
(H3)
will FLASH.
85 °C.
23