Before Calling For Service - KENMORE ELITE 796.6162 Serie Manual De Uso

BEFORE CALLING FOR SERVICE (continued)
Exhaust ducts are blocked, dirty, or
duct run is too long.
Clothes take too long to dry
Load is not properly sorted.
Large load of heavy fabrics.
Dryer controls are not set properly.
Lint filter needs to be cleaned.
Confirm that the exhaust duct is properly
configured and free of debris, lint, and
obstructions. Make sure that outside wall
dampers can open properly and are not
blocked, jammed, or damaged.
Clothes are wrinkled
Clothes are shrinking
Separate heavy items from lightweight items.
Larger and heavier items take longer to dry.
Light items in a load with heavy items can foo!
the sensor because the light items dry faster.
Heavy fabrics take longer to dry because they
tend to retain more moisture. To help reduce
and maintain more consistent drying times for
large and heavy fabrics, separate these items
into smaIler loads of a consistent size.
Use the appropriate control settings for the
type of load you are drying. Some loads
may require an adjustment of the DRY LEVEL
setting for proper drying.
Remove the lint from the filter before every
load. With the lint removed, hold the filter up
to a light to see if it is dirty or clogged. If it
looks dirty, follow the cleaning instructions on.
With some loads that produce high amounts
of lint, such as new bath towels, it may be
necessary to pause the cycle and clean the
filter during the cycle.
House fuse is blown, circuit breaker Reset circuit breaker or replace fuse. Do
has tripped, or power outage has not increase fuse capacity. If the problem
occurred, is a circuit overload, have it corrected by a
qualified electrician.
Dryer is overloaded.
Dryer is under loaded.
Clothes dried too long (over dried).
Clothes left in dryer too long after
cycle ends.
Garment care instructions are not
being followed.
NOTE: Due to the design of electric dryers, it
is possible for a circuit problem to allow an
electric dryer to run without heat.
Divide extra large loads into smaller loads for
better drying performance and efflcienc_:
If you are drying a very small load, add a
few extra items to ensure proper tumbling
action. If the load is very small and you are
using AUTO DRY cycles, the electronic control
cannot properly sense the dryness of the toad
and may shut off: too soon. Use TIMED DRY or
add some extra wet clothes to the load.
Over drying a load of laundry can lead to
wrinkled clothes. Try a shorter drying time or
LESS DRY setting and remove items while they
still retain a slight amount of moisture.
Use the WRINKLE GUARD option. This feature
will tumble the clothes briefly every few
minutes for up to 150 minutes to help prevent
wrinkling: .................................
To avoid shrinking your clothes, always consult
and follow fabric care instructions. Some
fabrics will naturally shrink when washed.
Other fabrics can be washed but will shrink
when dried in a dryer. Use a low or no heat
setting.
32