Tabla de contenido
Idiomas disponibles
Idiomas disponibles
VENTING
THE DRYER
(continued)
Routing and Connecting Ductwork
Follow the guidelines below to maximize dryer
performance
and reduce lint buildup and condensation
in the ductwork.
NOTE: Transition duct and fittings are NOT included
and must be purchased separately.
• Use 4 inch (102mm) diameter rigid or semi-rigid
metal duct.
° The exhaust duct run should be as short as possible.
* Use as few elbow joints as possible.
* The male end of each section of exhaust duct must
point away from the dryer.
° Use duct tape on all joints. Never use screws.
" Insulate ducts that run through unheated areas in
order to reduce condensation and lint buildup on
duct surfaces.
o The total length of semi-rigid metal transition duct
should not exceed 8 ft. (2.4 m).
WARNING:
Failure to follow these
guidelines will result in poor performance,
product
failure, and/or
result in fire or death.
IMPORTANT: Failure to exhaust the dryer, per the
guidelines included within these instructionstmay
result in unsatisfactory
dryer performance.
All venting
and ductwork beyond the exterior of the dryer is the
responsibility
of the consumer. Product failure, as
a result of improper venting, is not covered by the
manufacturer's
warranty.
Connecting
the Dryer
Vent
Verify all ducts and elbows are clean and free
from any blockages.
O
Measure duct length. DO NOT exceed the
maximum length listed in the Duct Length Chart.
O
Connect dryer exhaust to existing duct.
* Only use duct tape or clamps.
° DO NOT use screws to secure ductwork.
° Use rigid or semi-rigid metal ducts.
° DO NOT use plastic or thin metal foil tubing
for ducrwork.
- The male end of each elbow must a_ways point in
the direction of the airflow.
NOTE: Be careful when moving the dryer into its
final location. Do NOT crush the duct. Make sure the
connections do not come loose.
Correct
Venting
incorrect
Venting
(
Male
U
Ends
0
14
Tabla de contenido
