Emptying The Bin; Cleaning The Hepa Filter Unit - Logik L16VB10E Manual De Instrucciones

Emptying the Bin

Always unplug the vacuum cleaner from the mains socket before emptying the bin.
1. Remove the hose connector from the cleaner. Unclip the
lever clasps and open the cover.
2. Use the bin handle to turn the bin anti-clockwise till it stops,
then lift the bin up.
3. To prevent the dust dispersing, lower the bin into your
dustbin. Take out the filter unit to empty the bin.
4. If you find the filter unit is blocked or dirty, follow the steps in
"Cleaning the HEPA Filter unit". If not, skip this step.
5. Relocate the filter unit back into the bin and then put them
back to the vacuum cleaner by aligning the tabs at the
bottom of the bin with the slots on the vacuum cleaner. Turn
the bin clockwise with the bin handle until it locks in place.
6. Close the cover and clip the lever clasps.

Cleaning the HEPA Filter Unit

Always unplug the vacuum cleaner from the mains socket before cleaning.
1. To take out the filter unit from the bin, tilt it a bit to get the
base past the inlet.
2. Hold the base then untighten the top of the filter unit.
3. Lift the mesh guard from the HEPA filter and shake out the
dust accumulated on the mesh guard gently over your
dustbin. You may rinse it gently under a running tap.
4. Shake out the dust accumulated on the HEPA filter. You may
soak it in warm soapy water for a few minutes, and then rinse
it under a running tap to remove all traces of soap. Do not
reassemble the filter unit until it is completely dry.
5. To reassemble the filter unit, hold the mesh guard with the
arrows pointing up, and lower it over the HEPA filter.
6. Fit the top of the filter unit to the top of the HEPA filter, and
turn it clockwise. Do not over-tighten it.
7. Relocate the filter unit back in the bin again, tilt it a bit to get
the base past the inlet.
GB
9