GET RPM DASH Guia página 4

C. RPM DASH INSTALLATION AND OPERATION
INSTALLATION
1. 2.
Fix the RPM Dash
in the selected point injector connector on the
on the motorcycle. It is motorcycle, which generally
recommended to install is located in the top or lower
it on the handlebar part of the throttle body.
or, alternatively, on For any specific indication,
the mudguard. Use refer to the motorcycle
the support bracket workshop manual.
included in the package
if necessary.
ATTENTION:
If working
motorcycle with two
injectors, make sure to
work on the main one.
EN
3.
Identify the original Disconnect the
connector
original injector.
Pass the RPM Dash
wiring to the injector,
making sure it does not
remain exposed, or in
any case is protected.
ATTENTION:
- Check that the wiring
does not obstacle the
free movement
the handlebar in both
directions;
- Check that the wiring
never obstacles
interferes
on a
moving components
of the motorcycle (e.g.
transmission) or with the
pilot (e.g. the boot area).
6
4.
Connect the male
and female RPM Dash
connectors to the female
and male connectors of the
injector on the motorcycle.
for the
of
ATTENTION:
Always make sure that
the connectors are
or
correctly associated;
with the
when
them, a "click" is heard
that indicates they are
connected correctly.
5.
Fix the eyelet of the
earth cable to a screw
located in a protected,
unpainted point on the
engine or the frame.
RPM DASH
INJECTOR
ATTENTION:
The earth cable eyelet
must be correctly
fastened in
connecting for the RPM Dash to
operate.
7
6.
Install the multi-
function button included
in the package on the
handlebar using the
relative clamp. Connect
the button connector to
the corresponding RPM
Dash wiring.
order
EN