Kohler K-10433 Guia De Instalacion página 4

3" (7.6 cm)
or Larger
2. Install the Supplies
CAUTION: Risk of restricted waterflow and product damage.
Use extreme care when bending the supply hoses to avoid
kinking and twisting. Hoses must not be taut after installation.
NOTE: If the sink is not installed, install it at this time. Be sure to
follow all instructions packed with the sink.
NOTE: If the sink installation requires that you coil the supply hoses
to obtain a good connection, maintain an inside coil diameter of at
least 3" (7.6 cm).
Position the hot and cold water supplies to not interfere with
other hoses.
Connect the supply hoses to the supply stops. Left is hot, right is
cold.
Tighten all connections.
3. Flush the Supply Lines
Place the valve outlet hose into a bucket or suitable container.
Slowly turn on the hot and cold supplies.
Slowly turn the faucet handle to the full cold ON position.
Let the water run for one minute to remove any debris.
Rotate the faucet handle to the full hot position.
Let the water run for one minute to remove any debris.
Turn the faucet handle to the OFF position.
1041080-2-C
Cold
Cold
Hot
4 Kohler Co.