Connecting To Your Amplifier - Yamaha NS-B330 Manual De Instrucciones

página de 24

/ 24
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

You need a commercially available speaker cable.

Before making connections, make sure that the amplifier is switched off.

■ Connections

The size and/or material of a speaker cable affects on the sound quality. Therefore, we recommend you to purchase a high-

quality speaker cable to exert the performance of this unit.

Note

• Connect the (+) terminals on the amplifier and the speakers using one side of the cable. Connect the (–) terminals on

both components using the other side of the cable.

• Connect one speaker to the left (L) terminals of your amplifier, and another speaker to the right (R) terminals, making

sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be unnatural

and lack bass.

• When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be

taken never to exceed the speaker's maximum input.

• The speaker may be damaged if certain sounds are continuously output at high volume level. For example, if sine waves

from a test disc, bass sounds from electronic instruments, etc., are continuously output, or when the stylus of a turntable

touches the surface of a disc, reduce the volume level to prevent the speaker from being damaged.

• In your AV receiver's speaker size settings, specify small (or "S") for all of the speakers.

• Please refer to the owner's manual that came with your amplifier or receiver.

■ How to connect the speaker cables

15 mm

(5/8")

Good

No Good

Note

• Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them.

• Do not insert the insulation coating into the hole. The sound may not be produced.

Loosen

Black (–)

Bare wire