Idiomas disponibles
Idiomas disponibles
MDS DIRECT
MDS DIRECT
GENERAL FEATURES
Once the equipment is installed it is possible to program the parameters corresponding to the access control functions.
At the end of this chapter there is a User Table where all the data referring to each of the users can be indicated.
The person in charge of performing this task is designated the Administrator.
It is advisable to carry out the «Access Control Functions» programming by following the steps in the order set out in this
manual.
Before starting to program these functions, we shall explain how to enter and exit programming mode, as this is always
done in the same way.
The steps for programming «Access Control Functions» are explained starting out from the Main Menu. To reach the
Main Menu, always follow the instructions listed in «Enter Programming Mode».
ENTER PROGRAMMING MODE
To enter programming mode you always have to take these steps to access the MAIN MENU. From
the Main Menu you can access the different SECONDARY MENUS, depending on the option selected.
D i a l F l a t N u m b e r
a n d p r e s s
NOTES:
The secondary Programming Code 19025 may be replaced by another. See « Change
Programming Code » section. The primary Programming Code CANNOT be changed.
In the primary Programming Code
selected for the system. See « Assigning Number of Digits » section. Regardless of the number
of digits chosen for the system, the secondary Programming Code 19025 will always have 5
digits.
EXIT PROGRAMMING OR ANY OTHER MENU
To exit Programming Mode, from the Main Menu or the different Secondary Menus, press the bell
%
button
, as many times as necesary.
Pag 50
Enter Code:
0
------
A%21A%
P R I M A R Y
P r o g r a m m i n g
Code
A%21A%
P r o g r a m m i n g C o d e :
ENTER
PROGRAMMING MODE
, the length may vary in line with the number of digits
%
M 1 2 3 4
- - - - -
p Co Pa De Ci
19025
S E C O N D A R Y
Programming Code
MAIN MENU
Capítulos
