Kohler K-705800 Guia De Instalacion página 19

Troubleshooting (cont.)
Troubleshooting Table
Symptoms
2. Water leaks at intersection of side panel
and wall jamb.
3. Water leaks under the door.
4. Water leaks between the door and side
panel.
5. Water leaks by the strike jamb.
Steam Leaks
NOTE: This product is designed to allow some steam to escape to allow for proper air movement.
1. Steam leaks around the wall jambs/above
the header.
2. Steam leaks around strike jamb.
Door Function
1. The door hits the threshold.
2. The door is difficult to open/shut.
3. The door opens too easily or unlatches on
it's own.
Kohler Co.
Recommended Action
A. From the outside the shower, apply silicone to the joint
where the side panel frame meets the wall jamb.
A. Verify all seals are in place. Refer to the "Assemble the
Door" section.
B. Adjust the door to decrease the gap between the
threshold and the bottom of the door. Refer to the "Adjust
and Secure the Door" section.
A. Contact the Customer Care Center to order service seal.
Press the seal onto the edge of the door panel.
A. Adjust the door to decrease the gap between the door
and the strike jamb. Refer to the "Adjust and Secure the
Door" section.
B. Adjust the wall jambs so the door contacts with the strike
seal. Refer to the "Adjust and Secure the Door" section.
A. Allow the leak area to dry to completely. Apply silicone
at all leak points.
A. Adjust the door to decrease the gap between the door
and the strike jamb. Refer to the "Adjust and Secure the
Door" section.
B. Adjust the wall jambs so the door contacts with the strike
seal. Refer to the "Adjust and Secure the Door" section.
A. Adjust the door to increase the gap between the door and
the strike jamb to 1/4" (6 mm). Refer to the "Adjust and
Secure the Door" section.
A. Adjust the door to increase the gap between the door and
the strike jamb so latches are not as tightly engaged.
Refer to the "Adjust and Secure the Door" section.
B. Adjust the wall jambs so the door contacts with the strike
seal. Refer to the "Adjust and Secure the Door" section.
C. Remove the bottom door seals and trim off one segment.
Reinstall the seals.
A. Adjust the door to decrease the gap between the door
and the strike jamb so latches are more tightly engaged.
Refer to the "Adjust and Secure the Door" section.
19 1144162-2-B