Kohler K-705800 Guia De Instalacion página 14

10. Install the Door
IMPORTANT! This steps requires two installers.
With the "Clean Coat" sticker towards the outside of the shower, lift the door panel and guide the
bottom pin of the door into the bushing in the threshold.
Lift the header and position the top pin of the door into the bushing in the pin block.
Press the header down into place, make sure side panel frame is fully engaged in the header.
Installer #1
Lift the door into a position so that the bottom hinge pin is above the bushing in the threshold.
Carefully lower the door so the hinge pin fits into the bottom bushing. Hold the door in place
while installer #2 aligns the top hinge pin.
Installer #2
Lift the header and position the door so the top hinge pin aligns with the bushing in the pin block
attached to the header.
Press the header down into place. Verify the lip of the side panel frame is engaged in the small
groove of the header.
NOTE: The door may require adjustment; do not make final adjustments until the header and handle are
installed.
1144162-2-B
Top Hinge Pin
Bottom
Hinge Pin
14 Kohler Co.