Troubleshooting Guide - Brita WHS - 101 Instrucciones De Instalación

household filtration
Test the Filter
• Slowly turn on the water supply.
• Press the red pressure-relief button on
top of the housing head to release any
trapped air.
• Check for any leaks between the head
and housing of the unit, and on the
inlet and outlet connections. If there
are any leaks, see the troubleshooting
guide.
• Flush for 40 minutes by keeping the
nearest faucet turned on.
8
Step 4
*
*
*
*
*
*
*
*
*
* Turn off the household water supply.
* Purge all water from the water lines by
turning on all faucets in your home and drain
completely.
* Tighten all fittings.
* Turn on the household water supply and
inspect for leaks.
* If leaks continue, disassemble the configured
unit, reapply plumber's tape or sealant, and
reinstall the Filter.
» If leaks continue, turn off the water supply and call
Customer Service or your local plumber.
household filtration
Troubleshooting
Guide
Leaks between
head assembly and
filter housing
Note: Place paper towels or rag under the filter
to catch any water drips.
Turn off household water supply.
Purge all water from the water lines by
turning on all faucets in your home and drain
completely.
Press the red pressure-relief button on top of
the housing head to release pressure.
Unscrew and remove the housing head from
the housing using the Filter Housing Wrench.
NOTE: Use a bucket to catch any water in the
housing.
Remove the black O-Ring and inspect. Clean
and lubricate with silicone grease.
Clean the groove in the top of the filter housing
where the O-Ring sits.
Place the clean, lubricated O-Ring back in the
groove.
Screw the filter housing back onto the housing
head and hand-tighten. Using the Filter
Housing Wrench, tighten 1/4 turn.
NOTE: Do not over tighten.
Turn on the household water supply and
inspect for leaks.
Leaks around
fittings
h
F
(