Troubleshooting Guide - Brita Redi-Twist USS-301 Manual De Instalación

direct connect to kitchen faucet
Install Redi-Twist
and Test for Leaks
• Hold the Redi-Twist™ filter with the
label facing you.
• Insert filter up into the system head
until the two nozzles seat into the ports.
• Turn the Redi-Twist™ filter from left
to right (as you face it) until it stops.
• Turn on the cold water shut-off valve.
• Turn on the new filter and faucet.
Allow the water to run for
approximately 10 minutes.
• Check for any leaks.
• If system is leaking, turn off cold
water shut-off valve and refer to

troubleshooting guide.

8
Filter
™
Step 3
Align Arrow
1/4 turn
direct connect to kitchen faucet
Troubleshooting
Guide
* Remove the Redi-Twist™ filter and inspect the
o-rings. Make sure they are in place and free
from dirt and particles.
* Install the Redi-Twist™ filter.
* Turn on the cold water supply valve and
turn on the filter faucet.
* Make sure Redi-Twist™ filter is fully into the
lock position.
* Turn off the cold water shut-off valve. Press
in the gray collar on the Inlet and/or Outlet
fittings. Remove tube and inspect. Repair/
replace tubing. Reconnect tubing. Ensure it
hasn't been crimped.
* Turn the cold water shut-off valve back on and
turn on the faucet for filtered water.
* Turn off the cold water shut-off valve to the
filter system.
* Locate the kitchen faucet adapter.
- If the 3/8" plastic tubing is leaking,
follow the previous steps.
- If the thread between the kitchen
faucet adapter and the kitchen faucet
stem is leaking, tighten more securely. If
leaking continues, disconnect the 3/8"
plastic tubing and remove the kitchen
faucet adapter. Wrap the kitchen
faucet adapter and the cold water supply
line with plumber's tape and re-install.
- Turn the cold water shut-off valve back
on and turn on the faucet for filtered
water.
» If leaks continue, turn off the water supply and call
Customer Service or your local plumber.
Leaks between system
head assembly and
Redi-Twist™ filter
Leaks around fittings
Leaks on Kitchen
Faucet Adapter
connection