Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Installing guide bar and saw chain
Open the box and install the guide bar and the saw chain on the power unit as follows.
WARNING!
The saw chain has very sharp edges. Use protective gloves for safety.
The saw chain and bar are packed separately in the carton.
Chain and guide bar
Use only the guide bar (13) and saw chain (14) according to the technical data of the product.
1.
Set the product on a suitable flat surface.
2.
Before removing, ensure the chain brake is disengaged. If in the engaged position, pull the
front hand guard/brake lever (11) backwards until it 'clicks' into position.
3.
Use the provided spark plug wrench (32) to remove the two retaining nuts (16) from the
side of the cover (18).
4.
If necessary adjust the tension pin (22b) by moving the tension screw (22a) with the
screwdriver (33) in or out until it reaches a position where the pin can be inserted into the
lower hole on the guide bar (13) (Fig. 3).
5.
The guide bar (13) should be fitted with the saw chain 'cutter' symbol at the top of the bar
(Fig. 4).
Fig.3
6.
Place the slot in the guide bar (13) over the two bolts (21). Push the guide bar (13) to the
left towards the sprocket (24) (behind the clutch (25)). Make sure the tension pin (22b) is
inserted into the lower hole on the guide bar (Fig. 5).
7.
Place the saw chain (14) over the sprocket (24) behind the clutch (25) and fit around the
guide bar (13). Make sure the chain is placed above the chain catcher (17) (Fig. 6).
Fig.5
Fig. 4
Fig. 6
43
Tabla de contenido
