Front Wheels - Foppapedretti MYO Manual De Instrucciones

GB
ASSEMBLY
OPENING (fig. 1, 2, 3, 4)
Press lever "A", in the direction of the arrow to release the "fastening hook".
Lift the handle upwards, folding it backwards to open out the chassis.
A click will show that it has been opened out fully. Lift the handle as shown in figure 4.
Chassis opened out correctly fig 4.
WARNING: make sure the chassis is locked in the open position.

FRONT WHEELS

Fitting the front wheels (fig. 5): Lift the chassis with one hand and insert the front wheels, with
the locking lever turned upwards on the wheel hub, as shown in figure. A click will indicate that
it has been fitted correctly. Check that both the wheels have been fastened correctly, if they are
pulled downwards they should not be released.
Removing the front wheels (fig. 6): press the locking device "A" and keeping it pressed, remove
the wheel from the hub.
REAR WHEELS
Fitting the rear wheels (fig. 7): Insert the wheel pin in the hole, a click will indicate it has been
fastened in place. Make sure that the wheel has been secured correctly, it should not come away
when it is pulled outwards. Repeat the operation for both wheels.
Removing the rear wheels (fig. 8): Press the button "A" on the wheel hub and, at the same time,
remove the wheel.
FITTING THE LOWER BASKET (fig.9,10, 11)
Insert the metal clip of the basket in the front basket holding hook, fig.9.
Fasten the rear clips of the basket "A" to the chassis as shown in figure 10, taking care to insert
the pin on the inner side of the clip, in the hole on the chassis (fig.11).
FITTING THE BUMPER BAR
Fitting the bumper bar (fig. 12): line the bumper bar up with the slots and press on both sides. A
click indicates that it has been fastened correctly.
Removing the bumper bar (fig. 13): press button "A" on both sides of the bumper bar and at the
same time pull to remove it.
Opening the bumper bar on just one side (fig. 14): press button "A" on one side of the bumper
bar and pull to open it like a gate.
FITTING THE SEAT - (for use as a pushchair)
Fitting the seat (fig.15): Position the seat as shown in the figure (forward facing). Line up and
insert the seat connector in its housing on the chassis. A click will show that it has been fastened
correctly.
WARNING: Before use, lift the seat to check that it has been secured correctly to the chassis.
Removing the seat (fig.16): Press the front button of the seat removal lever and keeping it pressed,
MYO 24