LIGHTING THE APPLIANCE
1. Read instructions before lighting.
2. Turn the regulator control valve to the OFF
position.
3. Turn the timer knob clockwise as far as it will go.
4. Slowly open the cylinder valve.
5. Have a standard match, fireplace match or long-
nosed propane lighter lit and place it over the
burner.
6. Press and hold the safety valve button while
slowly opening the regulator control valve,
keeping face and body away from the top of the
cooker stand.
7. After the burner is lit, continue to hold down the
safety valve for 10-15 seconds. If the safety
valve is not held down for 10-15 seconds, the
flame will not stay lit.
8. If ignition does not occur in 5 seconds, turn the
burner control(s) off, wait 5 minutes, and repeat
the lighting procedure.
9. If the appliance fails to ignite after the second
attempt, see the troubleshooting section of the
manual and/or call our Customer Service
Department at U.S.A: 1-800-913-8999.
NOTE: Timer cycle is set at about 15 minutes. If the
timer is not reset before the 15 minutes are up, the
burner will shut off automatically. If this happens,
just re-light according to the instructions above and
continue to cook.
THERMOCOUPLE POSITION
If the burner will not light, check the position of the
thermocouple. The nut that holds the thermocouple
should be installed correctly and locked in place.
The flame will not stay lit unless it has full contact
with the thermocouple.
TURNING LP COOKER OFF
Turn all knobs to OFF position, turn LP tank OFF by
turning hand-wheel clockwise to a full stop.
CAUTION: Never allow oil or grease to get hotter
than 400 ºF or 200 ºC. If the temperature exceeds
400 ºF (200 ºC) or if oil begins to smoke,
immediately turn the burner or gas supply OFF
and wait for the temperature to decrease to less
than 350 ºF(175 ºC) before relighting burner
according to the manufacturer's instructions. If
there is a lid (cover), do not remove the lid.
Operating instructions
Step 2
23
OFF
Match
Step 4-5
Step 6-7
Thermocouple Position
Step 3
ON
Counterclockwise to
open the gas supply
Push and hold