Regulatory Information - Heath Zenith 7368 Manual Del Usuario

6
C. POSSIBLE CAUSE: Chime and push button/sensor are installed too far
apart.
C. CORRECTIVE ACTION: Locate chime closer to push button/sensor.
3. PROBLEM: Chime sounds when not intended (false triggers).
POSSIBLE CAUSE: Chime is receiving interference from another wire-
less device.
CORRECTIVE ACTION: Reset chime.
• PUSH BUTTON
• Remove push button battery. Wait 30 seconds.
• Press and hold the push button for 10 to 15 seconds within 60
seconds after installing battery into the push button.
• Press and hold the button on the chime until the chime sounds a
"Beep-Beep-Beep-Beep".
• To re-sync the push button and chime, press and hold the button
on the chime until the chime sounds a "Beep-Beep".
• Press the push button within 30 seconds. The chime will sound a
"Beep-Beep" tone to indicate the push button is synced.
• Press the push button to ensure operation.
• SENSOR
• Remove sensor battery. Wait 30 seconds.
• Press and hold the button inside the sensor for 10 to 15 seconds
within 60 seconds after installing battery into the sensor.
• Press and hold the button on the chime until the doorbell sounds a
"Beep-Beep-Beep-Beep".
• Re-sync the chime to the sensor. Press and hold the button on the
chime until the chime sounds a "Beep-Beep".
• Press the button inside the sensor within 30 seconds. The chime
will sound a "Beep-Beep" tone to indicate the sensor is synced.
• Press the button inside the sensor again to ensure operation.
Note: The push button/sensor and chime come synced from the factory. The
range of the wireless chime can vary with location, temperature, and battery
condition.
This device complies with Part 15 of the FCC Rules and RSS-210 of Industry
Canada. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved by
the party responsible for regulatory compliance could void the user's authority
to operate the equipment.
Helpful Videos – www.hzsupport.com

Regulatory Information

Helpful Answers – 1-800-858-8501