Installation Instructions; Installation Process - Audi 8V0 054 630 A Manual De Montaje

Installation instructions

Genuine Park Distance Control, Audi A3 2012 ➤
Scope of delivery:
◆
1 x control unit
◆
1 x buzzer
◆
4 x sensor
◆
4 x covering ring
◆
1 x fitting material
Required special tools, test and measuring equipment and auxiliary equipment:
◆
Flat-headed screwdriver
◆
Phillips head screwdriver
◆
Side cutters
◆
Hand drill
◆
Set of spiral drill bits
Forstner bit or step drill ∅ 20
◆

Installation process:

Note
◆
The Genuine Park Distance Control system should be fitted by an authorised workshop. Incorrect fitting may result
in damage to the vehicle or the Park Distance Control system.
◆
The work to be performed on the vehicle, as described in these installation instructions, may vary in some
circumstances as a result of model improvement measures. As such, changes to the wiring colours or even the
fitting sites should not be discounted. In view of this, please ensure that you always use the appropriate current
circuit diagram or the current vehicle workshop manual.
◆
All rights to make technical changes reserved.
1.1 Painting the sensors
Note
◆
The sensors only require painting in the car colour in the case of painted bumpers. If the bumpers are not painted,
the sensors do not require painting.
◆
Do not clean the sensors with a silicone remover prior to painting. Use a mild alcohol instead, e.g. industrial
alcohol.
◆
When painting the sensors leave them in the packaging supplied. This is provided as a painting device.
◆
Additional general information concerning painting:

Self-study programme No. 214/215
Page 2 – Fig. 1
The figure gives an example of the covering rings -1- already placed in the correct position on the sensors -4-.

Place the covering rings -2- on the rubber membranes of the sensors -3-.

Paint the sensors -3- and -4- evenly and not too thickly in the same colour as the vehicle.

Carefully remove the covering rings -1- and -2- using tweezers directly after painting (while the paint is still wet)
and let the paint dry.
Note
The covering rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.

Repaint as necessary after drying (e. g. clear varnish for twin coat painting).
◆
1 x power supply wiring harness
◆
1 x sensor wiring harness
◆
1 x assembly instructions
◆
1 x operating instructions
◆
Round file
◆
Pencil
◆
Measuring and cutting tool
◆
Centre punch
◆
Tweezers
◆
-VAS 1978- wiring harness repair set
8V0 054 630 A
23