Remote Control - Yamaha C-5000 Manual De Instrucciones

AMP OPEN/CLOSE
1
BAL
PHONO
1
CD
TUNER
SOURCE
VOLUME
16

Remote control

CD
2
BAL
UNBAL
2
LINE
EXT.DIRECT
BAND
PRESET
LAYER
MUTE
A.
Infrared signal transmitter
Outputs infrared control signals toward the unit.
B. A AMP key
Turns on the power to the unit or switches it to standby
mode. For more information regarding standby mode,
refer to "Front panel" (page 6).
C.
Input select keys
Enable you to select the input source to be played back.
BAL: Selects the component connected to the XLR-type
BAL 1 or BAL 2 jacks as the input source.
PHONO: Selects the turntable connected to the PHONO
jacks (XLR-type or RCA) as the input source. Press the
BAL key to select the source at the XLR-type jacks, or
the UNBAL key to select the source at the RCA jacks.
LINE: Selects the component connected to the RCA-type
LINE 1 or LINE 2 jacks as the input source.
EXT DIRECT: Selects the component connected to the
EXT. IN jacks as the input source. If EXT. DIRECT is
selected as the input source, audio signals will not be
output at the LINE 2 OUT or PHONES jacks.
CD: Selects the component (usually, a CD player)
connected to the RCA-type CD jacks as the input source.
TUNER: Selects the component (usually, a tuner)
connected to the RCA-type TUNER jacks as the input
source.
Note
Audio signals of the selected input source will be output at
the LINE 2 OUT (recording) jacks . If LINE 2 is selected as the
input source, audio signals will not be output at the LINE 2
OUT (recording) jacks .
D. Tuner control keys
Enable you to control the functions of the connected
Yamaha tuner. Use the BAND key to switch the reception
band, and the PRESET er keys to select a preset
station. For more information, refer to the owner's
manual for your tuner.
Note
Some Yamaha tuner models might not support these key
functions .