Optional Accessories; Tool Use & Setup; Intended Use - Stanley SB25PT-05 Manual De Instrucciones

O RIGINAL INSTRU CT I ON

2.5 OPTIONAL ACCESSORIES

WARNING: Since accessories, other than those offered by STANLEY Engineered Fastening® have
not been tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only STANLEY Engineered Fastening® recommended accessories
should be used with this product. Consult your dealer for further information on the appropriate
accessories.
WARNING: To reduce the risk of serious personal injury, disconnect battery pack before making
any adjustments or removing/installing attachments or accessories.
STANLEY Engineered Fastening policy is one of continuous product development and
improvement and we reserve the right to change the specifi cation of any product without
3. TOOL USE & SETUP

3.1 INTENDED USE

The Speed Rivet Placing Tool tools are designed for installation of STANLEY Engineered Fastening speed
fasteners ONLY. This tool is a professional power tool.
READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE PUTTING TOOL INTO
SERVICE.
WARNING: Never modify the power tool or any part of it. Damage or personal injury could
result.
DO NOT use under wet conditions or in presence of fl ammable liquids or gases.
DO NOT let children come into contact with the tool. Supervision is required when inexperienced
operators use this tool.
- Young children and the infi rm. This appliance is not intended for use by young children or
infi rm persons without supervision.
- This product is not intended for use by persons (including children) suffering from diminished
physical, sensory or mental abilities; lack of experience, knowledge or skills unless they are
supervised by a person responsible for their safety. Children should never be left alone with
the product.
ELECTRICAL SAFETY
The electric motor has been designed for one voltage only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger
corresponds to that of your mains.
Your DEWALT charger is double insulated in accordance with EN60335; therefore, no earth wire is
required.
Using an extension cable
An extension cord should not be used unless absolutely necessary. Use an approved extension cable
suitable for the power input of your charger (see technical data). The minimum conductor size is 1mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Before Use
• Select relevant size nose equipment and install
• Ensure that the battery is fully charged
• Insert Battery Pack into the tool
• Quickly pull and release the trigger to set the tool to the home position.
14
prior notice.
2 ;