Assembly And Operation; Cleaning The Tool; Environmental Protection - Worx WG547E Manual Original

OPERATION
INTENDED USE:
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.
ASSEMBLY AND
OPERATION
ACTION
ASSEMBLY
Assembling & disassembling the blower
tube
Installing & removing the battery pack
NOTE : Press the battery release button
to release battery pack from your tool.
After recharging, insert the battery pack
into tool's battery port. A simple push and
slight pressure will be sufficient.
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger's
manual.
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices. Never
insert or allow metallic objects into your
charger or battery pack connections
because of an electrical failure and
hazard will occur.
OPERATION
Starting & Stopping
WARNING! The tool runs for a
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool down.
Cordless Li-Ion Blower/Sweeper
Adjusting the blowing speed with
2-speed switch
USER TIPS
- Hold the blow tube approximately 8"
above the ground when operating the
tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front of
you.
- After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
FIGURE
CAUTION!
See Fig.
- Do not blow hard objects such as
A, B
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning
See Fig.
debris from stairs or other tight
C, D
areas.
- Wear safety goggles or other
suitable eye protection, long pants,
and shoes.
To store your cordless blower
Note: You can store your cordless blower
by hanging it on the wall with your own
wall hanging support at the back of the
blower.
See Fig. E

CLEANING THE TOOL

Clean the tool regularly.
WARNING! Keep your product dry.
Under no circumstances spray with
water.
- To clean the tool, use only mild soap and a
damp cloth.
- Do not use any type of detergent, cleaner
or solvent which may contain chemicals
See Fig. F
that could seriously damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is not
required.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling
advice.
See Fig. G
See Fig. H
11
EN