Assembly And Operation; Cleaning The Tool - Worx WG521 Manual Del Usuario

ASSEMBLY AND
OPERATION
ACTION
Assembling & disassembling the
Blower Tube
Attaching the Extension Cord
Starting & Stopping
WARNING: The tool runs for
a few seconds after it has
been switched off. Let the motor
come to a complete standstill
before setting the tool down.
Using the Blower
Hold the blow tube approximately
8—20cm above the ground when
operating the tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front
of you.
After blowing the debris/leaves
into a pile, it is easy to dispose of
the pile.
CAUTION!
—Do not blow hard objects such as
nails, bolts, or rocks.
—Do not operate the blower near
bystanders or pets.
—Use extra care when cleaning de-
bris from stairs or other tight areas.
—Wear safety goggles or other
suitable eye protection, long pants
and shoes.
Adjusting the Blowing Speed-
Variable speed
STORAGE
Store the blower and extension cord indoors, in
a cool dry location, out of reach of children and
animals.

CLEANING THE TOOL

Clean the tool regularly.
WARNING! Keep your product dry.
Under no circumstances spray with water.
— To clean the tool, use only mild soap and a damp
cloth.
— Do not use any type of detergent, cleaner or
solvent which may contain chemicals that could
seriously damage the plastic.
— Self lubricating bearings are used in your
product, therefore lubrication is not required.
12A Electric Blower
FIGURE
See Fig. A&B
See Fig. C
See Fig. D
See Fig. E
See Fig. F
9
EN