Operation Of The Heater - Orbegozo CV 2650 Manual De Instrucciones

CV 2650
Place the heater onto the upper left and right brackets then hold them in place.
Notes: In above mode of wall mounting, you only need to use a plastic wall plug and 2 screws
(long one) to fix the upper left and right brackets onto the wall.
Use 2 plastic wall plugs and 2 screws (long one) to fix the below left and right brackets onto
the wall after drilling holes on the wall if the heater is to be installed at the height below 1
meter from the floor.

OPERATION OF THE HEATER

NOTE: It is normal when the heaters are turned on for the first time or when they are turned
on after having not been used for a long period of time the heaters may emit some smell and
fumes. This will disappear when the heater has been on a short while.
Choose a suitable location for the heater, taking into account the safety instructions above.
Insert the plug of the heater into a suitable socket.
Turn THERMOSTAT KNOB fully in a clockwise direction to the maximum setting.
Turn on the heating elements by means of HEATER SWITCHES on the side panel. When the
heating elements are on the switches will illuminate. For maximum heat output both switches
should be on.
When the desired room temperature has been reached, the thermostat knob should be turned
slowly anti-clockwise until the thermostat is heard to click off and the lights on the element
10