To Switch On, Stop And Switch Off The Product; Operation Selection Start; Operation; Operating Mode, Park - Husqvarna AUTOMOWER 430XH Manual De Usuario

You can also switch on/off
mode and Spiral cutting , or save
your settings in different Husqvarna recommends to let
ECO mode be turned on to save
energy and avoid interference with
other equipment.
4.1 To switch on, stop and switch off
the product
• To switch on the product set the main
1 . The product can only start if it
switch to
is switched on and the correct PIN code
has been entered.
• To stop to product, push the STOP button
on top of the product. The product stops
and the blade motor stops.
• To switch off the product set the main
switch to 0 .

4.2 Operation selection START

Push the START button to select one of the
following operating modes:
Main area: The standard operating mode
•
where the product mows and charges
automatically.
Secondary area . When mowing
•
secondary areas this setting must be chosen.
If the product charges in the
area mode, it will fully charge, drive out
about 50 cm / 20 in. and then stop. This
indicates that it is charged and ready to
start mowing. If the main work area has to
be cut after charging, it is appropriate to
1352 - 001 - 09.12.2019
ECO
Profiles .

4 Operation

switch the operation selection to
area before placing the product in the
charging station.
Override Schedule . Any Schedule
•
settings made can be temporarily
overridden by selecting
schedule . It is possible to override the
Schedule for 24 h or 3 days.
Spot Cutting . The product works in a
•
spiral pattern to cut the grass where it has
been mown less than in other parts of the
lawn.
The
the START button. You can select how
the product should continue to work once
mowing is finished by pressing right arrow
and then specifying
Secondary Area .

4.3 Operating mode, PARK

When the PARK button is pushed the
following operation selections can be chosen.
Park until further notice: The product
•
Secondary
stays in the charging station until another
operating mode is selected by pushing
the START button.
• Start again in 3 hours: The product stays
in the charging station for three hours and
Accessories
This menu handles the settings for
the product accessories, for
®
example Automower
Contact your local Husqvarna
representative for information on
what accessories are available for
your product.
Override
Spot Cutting function is activated with
Main Area or
Operation - 13
Connect.
Main