Parts Supplied - Jennair 30" Instrucciones De Instalación

Parts Supplied

Check that all parts are included.
Anti-tip bracket kit
■
A
A. Anti-tip bracket
B. #8-18 x 1" (2.5 cm) Phillips head screws (4)
NOTE: Anti-tip bracket must be securely mounted to
subfloor. Thickness of flooring may require longer screws
to anchor bracket to subfloor. Longer screws are available
from your local hardware store. See the "Install Anti-Tip
Bracket" section.
Burner grates
■
Burner caps
■
Griddle drip tray (on griddle models)
■
B
Parts Needed
All models must be installed with a backguard if installing
■
at zero clearance to a combustible back wall surface such
as drywall. Alternatively, zero clearance to a back wall is
acceptable provided the surface of the entire back wall
above the range and below the hood is covered with a
non-combustible material such as tile or stainless steel.
See "Cabinet Dimensions" in the "Location Requirements"
section for installation requirements.
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See the "Electrical Requirements"
and "Gas Supply Requirements" sections.
It is recommended that all electrical connections be made by
a licensed, qualified electrical installer.
High Altitude Conversion
Reorificing of this range/rangetop is not required for proper
operation. Low burner rates may require resetting for best
results.
Adjusting Simmer Low and Main Low Settings
Refer to the "
on Surface Burner for Propane
Propane Gas Operation.
Adjusting Simmer Low and Main Low Settings
Refer to the "
on Surface Burner for Natural Gas
Natural Gas Operation.
" section (page 18) for
" section (page 28) for
5