Jennair 30" Instrucciones De Instalación página 30

6. Pull the grill orifice holder out of the burner box far enough
away to allow access to the orifice with a wrench, using
caution not to kink the attached tubing.
A. Grill orifice
B. Grill orifice holder
7. Using an adjustable wrench and a 1/2" (1.3 cm) open end
wrench remove the Propane (L) orifice spud and replace with
the correct Natural Gas (NG) orifice spud. See Natural Gas
Orifice Spud Chart.
8. Reposition the grill orifice holder assembly back into the
burner box, and replace the grill orifice holder bracket and
two holder screws.
9. Lift up on the control console and set it back into place. For
a proper fit, the flange of the control console must hook over
the lip on the front of the range cooktop.
NOTE: It may be necessary to lift valve stems to align with
console holes.
A
B
A. Control console flange
B. Front lip of range cooktop
30
A
B
Use 1/2" (1.3 cm)
open end wrench
to remove/replace
orifice
Hold with adjustable
wrench here
10. Check that the control console is flush with the top edge of
the range.
A
A. Flush with range top
11. Replace the screws on each side of the control console.
12. Replace the control knobs and bezels.
13. Replace burner grates.
Convert Oven Bake Burner (30" [76.2 cm] and
36" [91.4 cm] models and the right oven cavity on
48" [121.9 cm] models)
1. Slide the bake burner cover to the right or left.
A
A. Bake burner cover
2. Lift up and remove oven bake burner cover, and set aside.
3. Using a 1/4" (6.4 mm) nut driver, unscrew oven baffle nuts
and remove oven baffle. Set aside.
A. Oven baffle
B. Oven baffle nuts
A
B