Any manual command (switch, button or lever) shall be
given only after being sure it is the correct on.
4.3 Routine Inspection
4.3.1 Precautions
Check the motor and the sliding and spinning parts of the
appliance, in case of abnormal noise.
Check the protections and devices so that they Always work
properly.
4.4 Operation
4.4.1 Advices
Do not work with long hair that may touch any part of the
appliance, because they may cause serious accidents. Tie
them up and to the back, cover it with a scarf.
- Only trained and qualified users can operate the appliance.
- NEVER operate the appliance without any safety equip-
ment.
4.5 After finishing work
4.5.1 Precautions
5. Analysis and Problems Solving
5.1 Problems, Causes and Solutions
This appliance was designed to operate with the need of minimum maintenance but the natural wearing caused by longer
use of the equipment may occasionally cause some malfunctions.
If any problem occurs with your equipment, the most common situations are listed below with recommended solutions.
Besides that, Skymsen has Authorized Technical Assistants that are happy to help. The List of Authorized Technical Assistan-
ts can be checked in the website www.skymsen.com.
PROBLEMS
- The machine does not switch on.
- Smoke or burnt smell.
- The appliance switch on but
when the product is placed it
stops or the blades turn slowly.
- Damaged cord.
- The product does not process.
- Cup is leaking.
CHART 02
CAUSES
- Lack of electric power
- Problems in the electrical circuit.
- Problems in the internal and external
electrical circuit.
- Problems with the motor.
- Failure during transport of product
- Product pieces are too large and do not
allow contact with the blade
- Blunt blade
- Damaged seal.
Always wash the appliance after using it. To do that, only
start cleaning it when it has come to a complete stop.
Put all components back to their functional positions before
turning it on again.
4.6 Maintenance
4.6.1 Dangers
Any maintenance with the machine in working situation is
dangerous.
TURN OFF THE APPLIANCE BY PULLING THE PLUG OFF THE
SOCKET DURING MAINTENANCE.
Always disconect the plug from the outlet in case of
emergency.
4.7 Advice
Electrical or mechanical maintenance must be done by
qualified personal for such operation.
The person in charge has to be sure that the machine is un-
der TOTAL SAFETY conditions when working.
- Check if plug is connected to its
socket and do as explained in item 3.1
Starting.
- Call technical assistance.
- Call technical assistance.
- Call technical assistance.
- Call technical assistance.
- Call technical assistance.
- Cut smaller pieces, about 3,5 cm.
- Call technical assistance.
- Call technical assistance.
SOLUTIONS
15