Nice BIO Serie Manual Del Usuario página 30

CHECKING THE CODE NUMBER IN THE MEMORIES
- Press the button on the receiver twice.
!
- Check the number of flashes that follow: each long flash is a full memory (252 codes); each
short flash is a code (i.e. 2 long + 10 short = >2 x 252 = 504 plus 10 = 514 codes).
If there are a lot of codes and you wish to stop checking, press and hold the button for 1 second.
CHECKING THE LEARNING LOCK
- Press the key on the receiver a while and wait for 2 flashes to indicate elapsed time (approx. 5 sec.);
!
- If the second flash lasts longer than the first, the lock is enabled;
- If both flashes are equally long, the lock is disabled.
EFFECTING THE LEARNING LOCK
- Press the key on the receiver a while and wait for 2 flashes to indicate elapsed time (approx. 5 sec.);
!
- Press the key during the 2nd flash and release it as soon as the LED switches off.
Two flashes will follow and the 2nd should last longer than the first to indicate that the lock is enabled. If this
does not occur, repeat the entire operation from scratch.
DISABLING THE LEARNING LOCK
In order to disable the learning lock, a previously authorized remote control is required.
- 3 0 -