MBM FTBE74A Manual De Uso E Instalación página 27

Every technical change has
an effect on the operation or
safety of the appliance and
must therefore be performed by
technical personnel of the manu-
facturer or by technicians who are
formally authorised by the same.
Failure to do so exempts the ma-
nufacturer from any liability for for
any possible resulting modifica-
tions or damage.
Upon arrival, check the inte-
grity of the appliance and its
components (e.g. power cord), pri-
or to use. In the presence of faults
do not start the appliance and con-
tact the nearest service centre.
Read the instructions befo-
re acting.
tions to be performed. As far as
personal protective equipment is
concerned, the European Com-
munity has issued Directives
which the operators must comply
with. Noise ≤ 70 dB.
It is forbidden the installation of
stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
Before making the con-
nections check the technical
data shown on the rating pla-
te of the appliance and the techni-
cal data in this manual. It is strict-
ly forbidden to tamper with or
remove the plates and picto-
grams applied to the equipment.
Disconnect all supplies, if
present (e.g. water - gas -
electrical) upstream the ap-
pliance whenever you need to
work in safe conditions.
Connect the appliance if
present, in the sequence of
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear protective
equipment suita-
ble for the opera-
- 5 -
the water, then to the gas network.
Ensure there are no leaks then
proceed with the connections to
the mains.
The appliance is not desi-
gned to work in an explosive
atmosphere and as such its
installation and use is categorically
prohibited in such environments.
Position the entire structure,
respecting the installation di-
mensions and characteristi-
cs indicated in the specific chap-
ters of this manual.
The appliance is not inten-
ded for recessed installation.
/ The appliance must be
used in a well ventilated area. /
The appliance must have free
drainage (not hindered or impe-
ded by foreign bodies).
Once the appliance is con-
nected to the power and
drain sources, it must re-
main static (fixed) in the place of
use and maintenance. Incorrect
connection may cause danger.
Use where appropriate flexi-
ble cable for connection to
the mains electricity supply
with characteristics not inferior to
the model H07RN-F. The supply
voltage supported by the cable
with the appliance working must
not differ from the nominal voltage
value ± 15% shown at the bottom
of the technical data table.
The appliance must be in-
cluded in an "Equipotential"
ground discharge system.
Drainage of the appliance
must be conveyed into the
grey water discharge net-
work in an open "glass" unsi-
phoned formation.
2.
EN