How To Use The Remote Control - Friedrich QuietMaster Electronic SS08R Guia De Funcionamiento

How to use the remote control (optional)*
6
Temperature
Cooler
2
Cool
3
Fan
Only
9
Timer Operation
On/Off Start
11
NOTE: Physical appearance of your remote control may vary.
Follow instructions for the illustration that best resembles your remote.
To start unit
1 POWER - Press the POWER button once. The unit
will automatically turn on in the mode and fan speed
it was last left on.
To set mode of operation
2 COOL - Press the COOL button to automatically
switch the operating mode to COOL.
3 FAN ONLY - Press the FAN ONLY button if you want
to run the fan only. You may want to use this feature
in conjunction with the FRESH AIR/ EXHAUST if
you want to bring outside air into the room, or exhaust
stale air. (The FRESH AIR / EXHAUST feature is
located on the front of the air conditioner near the top.
See page 7, Figure 6.)
4 MoneySaver - Press the MoneySaver
®
activate the MoneySaver
the feature that cycles the fan with the compressor so
that the fan does not run all the time.
*
A Friedrich RC1 wireless remote control can be used to operate all QuietMaster
SS10R, SS12R, SS14R and SS18R. To add an RC1 remote to other Friedrich models, please visit your local authorized Friedrich Dealer.
6
Figure 4
®
5
1
Warmer
7
POWER
4
Fan Money
Speed Saver
®
10
Stop Set Hr.
8
button to
®
® feature. MoneySaver
To adjust temperature
5 WARMER - Press the TEMP
temperature setting.
6 COOLER - Press the TEMP
temperature setting.
To adjust fan speed
7 FAN SPEED - Press the FAN SPEED button to see the
current setting. Press again to change the fan speed.
F1 is the lowest setting (SLEEP SETTING), F2 is low
speed (LOW), F3 is medium (MED), and F4 is high
(HIGH).
To set the hour clock
8 SET HOUR CLOCK - Press SET HOUR once to
see the current clock setting. Continue pressing the
button until you arrive at the current time. MAKE
SURE YOU SET THE A.M. AND P.M. PROPERLY.
(NOTE: MINUTES ARE NOT SHOWN ON THE
DISPLAY.) A light will appear in the upper left corner
of the display when the hour is P.M.
To set the timer
NOTE: Set the hour clock before attempting to set
timer functions. You can set the timer ON/OFF a
minimum of one hour apart, and a maximum of 23
hours apart.
9 TIMER START - Press START to view the current
start time for cooling. Continue pressing the START
button until you arrive at the start time you desire. The
start time for cooling will then be set.
10 TIMER STOP - Press the STOP button. Continue
pressing the STOP button until you arrive at the stop
time you desire. The stop time for cooling will then
be set.
11 TIMER ON/OFF - Press the ON/OFF button once
to activate (light on) or deactivate (light off) the
timer. Once the START and STOP times have been
selected, they will remain in memory, and cycle daily
until changed.
NOTE: If the unit is unplugged or the power is interrupted,
® is
the HOUR CLOCK must be reset or the TIMER ON/OFF
functions will not work.
Electronic models. A remote is included with the SS08R,
®
button to raise the
button to lower the