Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll Rand 7802SA Manual Del Usuario

Product Safety Information

Intended Use:
It is designed to cut steel, aluminum, tin and other materials up to 20 gauge (1 mm).
For additional information refer to Product Safety Information Manual Form 04580494.
Manuals can be downloaded from ingersollrandproducts.com.

Product Specifications

Handle
Models
Type
7802SA Pistol
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16573818 and table on page 2. Maintenance frequency is shown in a circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
04580502_ed5
Max.
Free
Material
Speed
Thickness
Strokes/ Gauge/
min. Inch/mm
4200 20/.04/1.0
WARNING
Sound Level dB(A)
(ISO15744)
† Pressure (L ) ‡ Power (L
P
83 94
* K = Vibration measurement uncertainty
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
EN
Vibration (m/s )
2
(ISO28927)
) Level *K
W
3.0 1.0
EN-1