Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Exhaust System Maintenance
The dryer interior and the complete exhaust system
should be inspected after one year of use and cleaned
if necessary. Inspect and clean exhaust duct every one
to two years as required thereafter. The weather hood
should be checked frequently to make sure the
dampers move freely, dampers are not pushed in and
that nothing has been set against them. This
maintenance work should be done by a qualified
service person.
WARNING
To reduce the risk of electric shock,
disconnect the electrical service to the dryer
before cleaning.
Exhausting the dryer in hard-to-reach locations can be
accomplished by installing the 521P3 Flexible Metal
Vent Kit, available as optional equipment at extra cost.
The kit comes in two halves that can be separately
attached to the dryer and wall outlet. Once attached,
the unit can be slid back into position.
521P3 FLEXIBLE METAL VENT KIT
Figure 44
34
W043
SWD605N
SWD605N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Dryer Airflow
Efficient dryer operation requires proper dryer airflow.
Proper dryer airflow can be evaluated by measuring
the static pressure.
Static pressure in the dryer's exhaust duct should be no
greater than that shown in Figure 45. (Check with
dryer running and no load.)
NOTE: This can be measured with a manometer
placed on the exhaust duct approximately 2 ft.
(61 cm) from the dryer. Refer to Figure 45.
1
2
MEASURING STATIC PRESSURE
1
Manometer
2
Exhaust Duct
Figure 45
MAXIMUM STATIC
PRESSURE IN
WATER COLUMN
0.6 inches (1.5 cm)
DR012A-IN
D012I
801504
Capítulos
Tabla de contenido
