Tabla de contenido
Idiomas disponibles
Idiomas disponibles
User Maintenance
Lubrication
All moving parts are sealed in a permanent supply of
lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.
Cold Weather Care
If the washer is delivered on a cold day (below
freezing), or is stored in an unheated room or area
during the cold months, do not attempt to operate it
until the washer has had a chance to warm up.
Vacations and Extended Non-Use
IMPORTANT: To avoid possible property damage
due to flooding, turn off the water supply to the
washer whenever there will be an extended period
of non-use.
Care of Your Washer
Use only a damp or sudsy cloth for cleaning the
control panel. Some cleaning product sprays may
harm the finish on the control panel or damage the
interior of the hood.
Wipe the washer cabinet as needed. If detergent,
bleach or other washing products are spilled on the
cabinet, wipe immediately. Some products will cause
permanent damage if spilled on the cabinet.
Do not use scouring pads or abrasive cleansers.
Do not lay sharp or rough objects on or against the
washer. The finish could be damaged.
The wash drum and window will need no particular
care although they may need rinsing or wiping after an
unusual load has been washed. Outside of window can
be cleaned with household window cleaner.
NOTE: Leave the loading door open to allow the
inside of the washer to dry out after use. This helps
prevent musty odors from developing. DO NOT
allow small children to play on or around the
washer.
800938
Maintenance
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Care of Your Dryer
Clean the lint filter before drying each load. The lint
filter may be washed if needed. Annually remove lint
filter and screw to vacuum the duct under it.
Ordinarily, the dryer cylinder will need no care.
Wipe the dryer cabinet as needed. If detergent, bleach
or other washing products are spilled on the cabinet,
wipe immediately. Some products will cause
permanent damage if spilled on the cabinet.
Do not allow sharp or rough objects to lean against the
dryer. The finish could be damaged.
Use only a damp or sudsy cloth for cleaning the
control panel. Some spray prewash products may harm
the finish on the control panel.
NOTE: The wiring diagram is located inside the
control panel.
CAUTION
Label all wires prior to disconnection when
servicing controls. Wiring errors can cause
improper and dangerous operation.
Exhaust System
The exhaust duct should be inspected after one year of
use and cleaned if necessary by a qualified service
person to remove any lint build-up. Inspect and clean
exhaust duct every one to two years as required
thereafter.
The weather hood should be checked frequently to
make sure the dampers move freely, dampers are not
pushed in and that nothing has been set against them.
Keep dryer area clear and free from combustible
materials, gasoline and other flammable vapors and
liquids.
Do not obstruct the flow of combustion and ventilation
air.
NOTE: Verify proper operation after servicing.
W049
23
Capítulos
Tabla de contenido
