Alliance Laundry Systems SWD441C Manual De Instalación página 23

Grounding and Wiring Instructions
The dryer must be connected to a grounded
G
metal, permanent wiring system; or an
equipment-grounding conductor must be run
with the circuit conductors and connected to the
equipment-grounding terminal or lead on the
dryer.
The dryer has its own terminal block that must be
G
connected to a separate branch, 60 Hertz, single phase circuit, AC (alternating current) circuit,
fused at 30 Amperes (the circuit must be fused
on both sides of the line). ELECTRICAL
SERVICE FOR THE DRYER SHOULD
BE OF MAXIMUM RATED VOLTAGE
LISTED ON THE NAMEPLATE. DO NOT
CONNECT DRYER TO 110, 115, OR
120 VOLT CIRCUIT. Heating elements are
available for field installation in dryers which are
to be connected to electrical service of different
voltage than that listed on nameplate, such as
208 Volt.
801504 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
If branch circuit to dryer is 15 ft. (4.50 m) or less
G
in length, use U.L. (Underwriters Laboratories)
listed No. 10 A.W.G. wire (copper wire only), or
as required by local codes. If over 15 ft. (4.50 m),
use U.L. listed No. 8 A.W.G. wire (copper wire
only), or as required by local codes. Allow
sufficient slack in wiring so dryer can be moved
from its normal location when necessary.
The power cord (pigtail) connection between
G
wall receptacle and dryer terminal block IS NOT
supplied with dryer. Type of pigtail and gauge
of wire must conform to local codes and with
instructions mentioned on the following pages.
The method of wiring the dryer is optional and subject
to local code requirements. Refer to Figure 26.
Installation
21