Makita XCU03 Manual De Instrucciones página 53

3.
working position.
release.
tool from the shoulder harness.
1
1. Buckle
Adjusting the hanger position
change the hanger position.
750 mm
1
(29-1/2")
1
2
3
unguarded part of the cutting tool
2
750 mm
(29-1/2") 100-300 mm
(3-15/16"-11-3/4")
3
the hanger to a comfortable working position and then
tighten the bolt.
1. Hanger 2.
Correct handling of the tool
WARNING:
right-hand side. Correct positioning of the tool allows
WARNING:
control of the tool at all times. Do not allow the
work vicinity.
operator.
WARNING:
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enters the
working area, immediately stop the operation.
CAUTION:
If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
Correct positioning and handling allow optimum control
13 ENGLISH
1
2
Always position the tool on your
Be extremely careful to maintain
To avoid accident, leave more
-