How To Use The Accessories - H.Koenig STC90 Manual De Utilización

Fig 10
How to clean dust cup
Steps to clean dust cup
1. Take out the dust cup as shown in Fig. 6.
2. Gently push the dust dump button to dump dust as shown in Fig. 7, 8.
3. In case the suction power is insufficient when the waste has not reached MAX, turn off the machine,
repeat the above steps 1-2, detach dust cup cover and take out the filter sponge for cleaning as shown in
Fig. 8, 9.
4. In case of cleaning the inside of the dust cup, please operate according to the following steps:
1) Rotate the dust cup cover to detach it and take out the filter sponge (Fig. 9);
2) Take out secondary filter system (Fig. 10);
3) Remove dust press panel and filter net (Fig. 11);
4) Wash the separator under water tap and then dry it out;
5) Reassemble the dust cup and install it.
Note: After cleaning the filter components, dry them first before putting back into the machine for use.
It is suggested to expose to sunshine for 24 hours until they are completely dry. Make sure each
component is back in place otherwise it may cause malfunction; do not allow water to get into the
electrical components otherwise it may cause malfunction.

How to use the accessories

1. Combined brush is suitable for picking up dust in small seams in window, furniture, corners, and dust
on short hair fabric furniture and inaccessible places. You may rotate the brush head as necessary.
2. Use the dusting brush to clean curtains draperies cushions and fabrics.
3. To vacuum carpets and rugs, push the brush switch to the carpet position
brushes up into the floor nozzle（Fig. 13）
4. to vacuum bare floors, push the brush switch to the bare floor position
brushes down from the floor nozzle（Fig. 14,15）
Fig.13
Fig 11
Fig.14
Fig12
.This will pull the
. This will extend the
Fig.15