Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PRECAUTIONS
IMPORTANT- The input voltage of the Ultrasonic Bath transducers can reach hundreds of volts. Therefore,
it is very important to observe the following Safety Regulations:
1) Do not open the lid when the power cord is connected to the power supply.
2) Do not spill water or any other conducting fluid over the unit's housing.
3) Always connect the unit to grounded power outlets.
♦ Connect the unit to a grounded 230 V, 50/60 Hz power outlet.
♦ Do not use inflammable solvents as cleaning solutions.
♦ Keep the unit unplugged before filling it. Do not fill the tank above the max. mark. Do not start up the unit
when the water level is below the min. mark.
♦ Do not allow children or unskilled people to handle the unit.
♦ Never submerge the unit in any liquid to clean it.
♦ Ultrasonic cleaning is not suitable for organic pearls.
♦ Do not open the unit while it is connected to the power supply.
♦ The machine lid may be hot after a cycle. Proceed with caution when removing it.
♦ If you are not sure of the effects of the cleaning solution on a given type of item, carry out a previous test with
a single item.
♦ Do not attempt to remove any screw or panel. The user does not need to manipulate anything inside.
♦ To prevent electric shock, never touch the power cord or socket with wet hands.
♦ Never operate the unit if the plug or the power cord is damaged. If the unit does not work properly, is damaged
or has fallen into the water, refer it to a technical service for examination and repair.
♦ Do not touch the unit if it has fallen into the water. Unplug it immediately.
♦ Use the unit properly according to the user's guide. Do not use accessories not recommended by the
manufacturer.
♦ The unit should never be left unattended when it is plugged.
♦ Do not operate the unit next to heat sources such as radiators.
♦ Install the unit on a dry and flat surface.
CLEANING SOLUTIONS
Cleaning solutions can be classified into two types: those with water as the basic element and cleaning solution,
and solvents.
The most common cleaning method is with water, as it has an acceptable capacity to dissolve inorganic substances.
However, it is extremely limited in dissolving organic substances. For this type of compound, water is a good
medium for the dispersion of waste particles, and a good support for specific detergents which dissolve organic
substances.
In most cases a mixture of water and domestic washing up liquid can be used as a cleaning solution. Nevertheless,
when the quantity or nature of dirt is resistant to this type of cleaning solutions, specific solvents for ultrasonic
baths have to be used. Under no circumstances should inflammable solvents or environmentally unfriendly
products be used.
TECHNICAL SPECIFICATIONS
Dimensions:
Max. length:
Tank dimensions:
Tank capacity:
Frequency:
Power supply:
Power:
Timer setting:
Weight:
10
243 x 164 x 228 mm
190 mm
168 x 138 x 66 mm
1400 ml
Min: 450 ml / Max: 1100 ml
42 kHz
AC 220-240V / 50Hz
70 W
2,7 kg
Tabla de contenido
