Important - American Standard VorMax Plus 708AA Serie Manual Del Propietário

CAUTION
:
IF A VORMAX PLUS FRESHINFUSER IS NOT SECURELY INSERTED INTO THE SPUD OPENING,
!
NOT FLUSH THE TOILET
VORMAX PLUS FRESHINFUSER INSERTED IN THE SPUD OPENING AT ALL TIMES WHEN FLUSHING THE TOILET.
For further assistance please call Customer Care at: (800) 442-1902
Confirm gaskets are fully seated on tank.
DO NOT REMOVE FACTORY
!
INSTALLED NUTS
Assembly of Housing Base Plate
Read carefully then remove CAUTION sticker (1) next
to spud (2) from rear of bowl.
Insert rubber grommets
(3) (narrow end rst) up
underneath the bowl and
into each seat mounting
hole. Ensure grommets
stay in place in bowl.
AS THIS MAY RESULT IN WATER LEAKING FROM THE TOILET. TOILET MUST HAVE A
5
GASKETS
7
1
2
3
Using the provided handle,
tighten the nuts alternately
until the tank contacts the front
and back of the bowl achieving
china-to-china contact.
NOTES:
a) To ease installation, push
down on the top of the tank
while tightening the nuts.
b) Tighten all three nuts
adequately.
IMPORTANT: Please do not connect the
water supply line until the last step
1
2
6
8
Check that rubber gasket is rmly
attached to the underside of the
base plate (1) and place plate
over Spud (2) and rear of bowl
while aligning the two mounting
holes through the bowl.
DO
5
pg