Handle Adjustment; Installation; Securing Child - Nuna pipa Manual De Instrucciones

Ocultar thumbs Ver también para pipa:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
Handle
adjustment
1 The handle of the infant car seat can be adjusted to 3
positions.
(12) -1
Baby chair position.
(12) -2
Rocking position.
Position for car, hand or stroller transportation.
2 To adjust the handle positon, squeeze handle buttons on
(13) -1
both sides to release it.
3 Rotate handle until it clicks into any of the 3 positions.

Installation

without base
1 Place the infant car seat onto the vehicle seat where you
wish to put it. Pull the vehicle safety belt out and lock it into
the vehicle buckle, sliding the vehicle lap belt into the side
guides of the infant car seat.
2 Slide diagonal belt into the rear guide.
3 Pull the vehicle shoulder belt to fasten the infant car seat
(16)
tightly and securely.
4 Level line on carrier must be level to the ground when the car
(30)
seat is installed.
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
After installing the infant car seat, always check that the
vehicle belts are routed correctly and securely fastened
into the vehicle buckle.
17
(12) -3
(13) -2
(14)
(15)
(17)
Securing
child
Foam inside infant insert is present to ensure that harness
fits child properly. Infant insert must be used for children 0-6
months.
After the child is placed into the seat, check whether the
Shoulder Harness Straps are at proper height.
1 While pressing the adjustment button located at the front of
the infant car seat, pull completely the two Shoulder Harness
Straps of the infant car seat.
2 Unlock the buckle of the harnesses by pressing the red
(19)
button.
3 Place the child into the infant car seat and lock the buckle.
(20)
(21)
Please refer to.
4 Tighten the shoulder harness straps by pulling the
(22)
adjustment webbing.
Make sure the space between the child and the Shoulder
Harness Straps is about the thickness of one hand.
Canopy
1 Unzip the zipper behind the front canopy bow.
2 Pull the canopy out of the compartment.
3 Attach the magnets on each corner to the front of the car
(25)
seat.
(18)
(23)
(24)
18
Tabla de contenido
loading

Tabla de contenido