Princess 242124 Manual De Instrucciones página 22

Switching on and off (fig. A)
To switch on the appliance, press the on/off
button (1). The start/stop button (2) flashes
red. The start/stop button (2) becomes green
when the appliance is ready for use.
To switch off the appliance at any time,
press the on/off button (1) again.
Pre-brewing function
The pre-brewing function makes sure that the
appliance initially only supplies a small quantity
of water. The coffee-making process continues
after a short interval.
Economic brewing function
If you switch off the appliance after preparing
a beverage, the economic brewing function
can be activated automatically. To activate the
economic brewing function, keep the start/stop
button (2) pressed. The start/stop button (2)
becomes green. The water level indicator (3),
the steam indicator (4) and the descaling
approximately 3 seconds. The economic
brewing function has been activated. If the
brewing process is completed, the appliance
will not heat anymore. The appliance switches
off automatically.
Stand-by mode
If the appliance is not used for more than
activated automatically. The start/stop button
(2) flashes red. To activate the appliance for
use, press the start/stop button (2) again.
If you turn the cup size selector (6) or the
beverage selector (7) or if you fill the water
reservoir (17) with water, the stand-by mode
is deactivated automatically.
Automatic switch-off function
The appliance switches off automatically if it is
has not been used for a period of 30 minutes.
Water level indicator (fig. A)
The fresh water supply is monitored
continuously by a float which moves up and
down in the water reservoir (17). The water
level indicator (3) flashes when the level comes
below the required minimum filling quantity.
Setting the cup size (fig. D)
The cup size selector is used to set the
required quantity of water to be delivered from
the appliance.
Set the cup size selector (6) to the required
position. Refer to the table below to set the
correct cup size.
Setting Cup size
A 1 cup of espresso
B 1 normal cup of coffee
C 1 large cup of coffee
D 2 normal cups of coffee
E 1 extra large cup of coffee
Selecting the beverage (fig. E)
The beverage selector is used to select the
type of beverage to be made.
Set the beverage selector (7) to the
required position. Refer to the table below
to select the correct beverage.
Setting Beverage
A Hot water
B Coffee
C Milk froth
D Cappuccino
E Latte macchiato
F Café au lait
Making coffee with coffee pads
(fig. A, C, D, E, F & I)
Use conventional coffee pads with an outer
diameter of 7 cm.
Caution!
- Do not use the following types of coffee
pads:
- coffee pads with an outer diameter
smaller than 7 cm;
- hard coffee pads for espresso makers;
- coffee pads with additives for cappuccino,
etc.
- Do not put damaged coffee pads, loose
ground coffee or instant coffee into the
coffee pad cassette.
22