Basic Cleaning - Princess 242124 Manual De Instrucciones

Cleaning the milk frothing unit
(fig. A, D, E & J)
Express cleaning
Set the beverage selector (7) to position
'C', 'D', 'E' or 'F'.
dispenser (10).
Fill the milk jug with cold water.
Put the flexible tube (24) into the milk jug.
Make sure that the milk frothing unit is
assembled and mounted correctly.
Wait until the start/stop button (2) illuminates
green.
Simultaneously press on/off button (1) and
the start/stop button (2) to start express
cleaning.

Basic cleaning

Disassemble the milk frothing unit.
Clean the milk froth dispenser (12),
and the milk froth dispenser adapter (26)
in soapy water using a soft brush.
Fully dry the parts of the milk frothing unit.
Assemble the milk frothing unit.
Tightly screw the red steam valve (27) to
the steam outlet (30).
Mount the milk frothing unit to the appliance.
Cleaning the red steam valve (fig. L)
The red steam valve must be cleaned monthly
or when the appliance clearly produces less
steam.
Manually remove the red steam valve (27)
from the steam outlet (30). If necessary, use
the hexagonal key (29) at the underside of
the coffee dispenser filter (28).
Note: If you do not manage to remove the red
steam valve, call our service number.
Clean the red steam valve (27) using the
descaling agent. Rinse the red steam valve
(27) under running water.
Manually screw the red steam valve (27) to
the steam outlet (30).
Replacing the anti-chlorine filter
(fig. A & B)
The anti-chlorine filter is available from our
service station. The anti-chlorine filter removes
chlorine and other contaminants from the water
for a pure coffee taste.
The anti-chlorine filter must be replaced every
two months at an average daily consumption
Remove the water reservoir (17) from the
appliance.
Remove the lid (19) from the water reservoir
(17).
Remove the cover (20) from the filter holder
(21).
Remove the anti-chlorine filter (18) from
the filter holder (21).
Rinse the new anti-chlorine filter (18) under
running water.
Place the anti-chlorine filter (18) in the filter
holder (21).
Place the cover (20) on the filter holder (21)
(fig. B).
Place the lid (19) on the water reservoir (17).
Place the water reservoir (17) in the
appliance.
Setting the water hardness range
(fig. A)
The appliance can be set to various water
hardness settings. The factory setting of the
water hardness is 4. Contact your waterworks
company or your local authorities for the water
hardness range in your area. If the water
hardness range in your area is lower than 4,
the water hardness setting can be changed to
reduce the number of times that the appliance
must be descaled.
Use the on/off button (1) to set the appliance
to the water hardness in your area. Refer
to the table below to set the correct water
hardness range.
Flashing Water hardness
signal range
1 (soft)
2 (medium)
3 (hard)
4 (very hard)
Press the on/off button (1) to switch off the
appliance.
Keep the start/stop button (2) pressed for
27
Water hardness
(°dH)
0 - 7
7 - 14
14 - 21
above 21