Princess 242124 Manual De Instrucciones página 21

16. Drip tray
17. Water reservoir
18. Anti-chlorine filter
Initial use
Preparation
Clean the dispenser cassette in soapy water
(fig. K).
Clean the coffee pad cassette and the
ground coffee cassette in soapy water.
Clean the cup tray and the drip tray in soapy
water.
Clean the water reservoir and the lid of the
water reservoir in soapy water.
Rinse the accessories under running water.
Deventilation (fig. A, B, C & J)
The appliance must be deventilated before
first use. Deventilation is only required for new
appliances.
Warning! Be careful with hot water and steam
to avoid burns. Hot steam can escape from
the milk froth dispenser during the process.
Caution!
- Only fill the water reservoir with fresh cold
water. Do not use carbonated water or other
liquids to fill the water reservoir.
- Do not exceed the maximum mark when
you fill the water reservoir.
Remove the water reservoir (17) from the
appliance.
Remove the lid (19) from the water reservoir
(17).
Remove the cover (20) from the filter holder
(21).
Place the anti-chlorine filter (18) in the filter
holder (21).
Place the cover (20) on the filter holder (21).
Place the lid (19) on the water reservoir (17).
Fill the water reservoir (17) with water up to
the maximum mark in the filling opening of
the lid (19).
Place the water reservoir (17) in the
appliance.
Set the locking collar (8) to position 'B'.
Insert the empty coffee pad cassette (13)
in the appliance.
Set the locking collar (8) to position 'A'.
Note: If the coffee pad cassette is not inserted,
the locking collar cannot be set to position 'A'.
dispenser (10).
Put the flexible tube (24) into the milk jug.
Press the on/off button (1) to switch on the
appliance.
Briefly press the start/stop button (2) to
start the deventilation. The water starts to
flow out of the coffee dispenser (10) after
approximately 30 seconds. The pump
switches off automatically.
Set the locking collar (8) to position 'B'. The
water is heated until the start/stop button (2)
changes from red to green after approximately
80 seconds.
Use
Designation of the indicators
Component Indication
Start/stop button (2) Red
Red flashing
Green
Green flashing Preparation in
Water level Yellow flashing Fill the water
indicator (3)
Steam indicator (4) Yellow flashing Descale the steam
Yellow
Descaling Yellow flashing Descale the appliance.
Yellow
21
Designation
The appliance is
heating or rinsing.
Stand-by mode.
The appliance is
ready for use.
progress.
reservoir.
device.
Active steam mode.
setting mode.
The descaling
program is running.